ここから本文です
TWO:CHAPTER VII. REIGN OF GEORGE III.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:THE MANSION HOUSE, LONDON, IN 1760.The worst of that was that there was no rear guard flanking that door!

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:Larry did not need to have the intricate signal relayed, nor did he wait to be told his passengers deduction. Their own maneuvers had given him a clue.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:On the opening of the Session, the king called the attention of Parliament to the state of Canada. That colony had flourished since it had come into the possession of Britain, especially since the passing of the Bill of 1774, which had given freedom to the Roman Catholic church there, the church of the French inhabitants. But one part of the colony was still inhabited by the descendants of the French, and another by those of the English and Americans. It was, therefore, found desirable to put an end to the competition which still existed, from differences of faith and of national sentiments and customs, between the two races, by dividing the colony into two provinces, the one inhabited by the French to be called Lower Canada, and the other, inhabited by the British, to be called Upper Canada. On the 25th of February the king sent a message to Parliament, proposing to carry out this division; and on the 4th of March Pitt moved to bring in a Bill for that purpose, and stated the intended plan of arrangement. Besides an elective assembly, each province was to have a Council, the members of which were to be appointed for life, with hereditary succession to the descendants of such as should be honoured with hereditary titles, which titles were to confer on an inhabitant of either province the dignity of a member of the Council. Landed property was to be held according to English law, in soccage tenure; the Habeas Corpus was to be established in both provinces. An allotment of lands was to be made for the Protestant clergy; but, as the majority of the inhabitants in the Lower Province would be Catholic, the Council and Assembly were empowered to allot lands also to their clergy, which allotment, on sanction of the Crown, was to be valid without intervention of Parliament. No taxes were to be imposed by the British Government except such as were necessary for the regulation of commerce, and these were to be levied by the provincial legislature to prevent any heartburnings like those which had occurred in the American States.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.